9 Axis Gyro Accelerator Magnetometer Module - MPU9250

MVR 240.00

Location	Male City/Male
Item Condition	New

Description

This module features the Invensense MPU-9250, which is a multi-chip module (MCM) consisting of two dies integrated into a single QFN package. One die houses the 3-Axis gyroscope and the 3-Axis accelerometer. The other die houses the AK8963 3-Axis magnetometer from Asahi Kasei Microdevices Corporation. Hence, the MPU-9250 is a 9-axis MotionTracking device that combines a 3-axis gyroscope, 3-axis accelerometer, 3-axis magnetometer, and a Digital Motion Processor (DMP). The MPU-9250 also features an embedded temperature sensor.
This module includes pull-up resistors on the SDA, SCL, and nCS lines, pull-down resistors on the FSYNC and AD0 lines, and an on-board 3.3V voltage regulator allowing you to power the module from 5V sources such as an Arduino. If you desire to power the module from 3.3V you can bridge the solder jumper next to the voltage regulator to bypass the regulator (refer to schematic link below).

PRODUCT CONTENTS:
1 piece - MPU-9250 Module
1 piece - Ten pin male header (1x10)

SPECIFICATIONS:
On-board pull-up resistors on SDA, SCL, and nCS
On-board pull-down resistors on FSYNC and AD0
3-Axis Accelerometer
Range: up to ± 16 g
Sensitivity: up to 16,384 LSB/g
3-Axis Gyroscope
Range: up to ± 2000 deg/sec
Sensitivity: up to 131 LSB/deg/sec
3-Axis Magnetometer
Range: ± 4800 µT
Sensitivity: 0.6 µT/LSB
Supply Voltage: 4.4 to 6.5 V or 3.3V if you solder the solder jumper near the on-board voltage regulator
Interface: I2C
I2C Address: 0x68 by default, 0x69 if AD0 is pulled high
Board Dimensions: 25.5mm (1.004") long x 15.4mm (0.606") wide, 3mm (0.118") inside diameter of mounting holes
Weight: 2.72g (0.096oz)